Correct The Settings For A Copy Job - Oce 2090 User Manual

Correct the settings for a copy job

Introduction
Task for operators
You can define or change the settings of a copy job until you press the Start key
or the Set-build key
editor. There you select the required job settings. Use the Correction key
to correct the settings.
How to correct the quantity setting for a copy job
Press the Correction key
1
prints).
Use the numeric keys to enter a new value.
2
Press the Start key
3
How to correct the settings in the copy job sections
Press the Correction key
1
the job editor. This action changes all the copy job settings back to the default
value.
Use the function keys above the operator panel to access the 4 copy job
2
sections.
Use the function keys below the operator panel to define the settings for each
3
section.
Press the Start key
4
The copy function
. When you create a copy job, you open the job
one time to reset the quantity setting (number of
to send the job to the job queue.
two times to reset the values in the 4 sections of
to send the job to the job queue.
107