Msconfigure - Brocade Communications Systems Brocade 8/12c Command Reference Manual

22

msConfigure

msConfigure
Configures the Management Server (MS) access control list (ACL).
SYNOPSIS
msconfigure
DESCRIPTION
Use this command to configure the MS Access Control List (ACL). The MS allows a Storage Area
Network (SAN) management application to retrieve and administer the fabric and Interconnect Elements,
such as switches. This application is located at the Fibre Channel well-known address, 0xFFFFFA.
If the MS ACL is empty (default), The MS is available to all systems connected to the fabric. By
populating the MS ACL with one or more world wide names (WWNs), you can restrict access to MS to
the specified WWNs.
This command is interactive and provides the following choices:
0
1
2
3
When changing the MS ACL by adding or deleting WWNs, you are prompted to save the new
configuration to nonvolatile storage. The saved MS ACL becomes effective upon reboot.
The MS ACL is implemented on a per-switch basis and should be configured on the switch to which the
management application is directly connected.
NOTES
When an FCS policy is enabled, the MS ACL is not used. In such a case, access to MS is controlled by
security by way of the MS_POLICY configuration.
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
This command is supported only in AD0 and AD255 contexts.
OPERANDS
None
EXAMPLES
To display the MS ACL:
514
Done
Display the access list
Add member based on its port/node WWN
Delete member based on its port/node WWN
switch:admin> msconfigure
0 Done
1 Display the access list
2 Add member based on its Port/Node WWN
3 Delete member based on its Port/Node WWN
select : (0..3) [1] 1
MS Access List consists of (5): {
20:01:00:60:69:00:60:10
20:02:00:60:69:00:60:10
20:03:00:60:69:00:60:10
20:02:00:60:69:00:60:03
Fabric OS Command Reference
53-1001764-01