Brocade Communications Systems Brocade 8/12c Command Reference Manual page 807

ipif
iproute
arp
vlantag
EXAMPLES
To display the IP interface and static route configured on Brocade 7800:
Fabric OS Command Reference
53-1001764-01
Displays the IP interface ID, IP address, netmask, and MTU for IPv4 addresses.
Displays the prefix instead of the netmask for IPv6 addresses. Flags are
explained in the command output (refer to the example below).
Displays the IP address, netmask, gateway, metrics, and flags. Displays the prefix
instead of the netmask for IPv6 addresses. A status flag for the IP routes indicates
if a route is used for the management interfaces. A route definition that uses one
of the internal interfaces has the words "Interface Management" printed at the end
of the line.
Displays the address resolution protocol (ARP) table. On the 7800/FX8-24
platform you can display the content of the ARP table, but you cannot modify its
contents. On the FR4-18i you can add static ARP entries using the portcfg arp
command.
-lmac
Displays the local MAC address. This operand is optional.
Displays the VLAN Tagging configuration. For each entry, the output displays the
IP interface address, the destination IP address, the VLAN ID, the L2 CoS priority,
and a flag. This display includes tunnel- and IPIF-level configurations. The
following flags indicate the type of configuration:
Perm
Permanent entry. Permanent entries are configured at the IP interface level with
the portCfg vlantag command.
Perm Net
Network-wide permanent entry. The same as the permanent entry except that no
destination address was defined (defaults to 0.0.0.0), so traffic to all destinations
is tagged.
App
Application layer VLAN configuration defined at the circuit level.
switch:admin> portshow ipif ge0
Port: ge0
Interface IPv4 Address
----------------------------------------------------------
0 192.168.0.20
1 192.168.0.21
Interface IPv6 Address
---------------------------------------------------------------
2 fe80::205:1eff:fec3:e6b2
3 2000::20
4 2000::21
5 2000::22
Flags: U=Up B=Broadcast D=Debug L=Loopback P=Point2Point R=Running
N=NoArp PR=Promisc M=Multicast S=StaticArp LU=LinkUp
switch:admin> portshow iproute ge0
NetMask Effective MTU Flags
255.255.255.0 1500
255.255.255.0 1500
Len Effective MTU
64 1500
64 1500
64 1500
64 1500
22
portShow
U R M
U R M
Flags
U R M
U R M
U R M
U R M
773