Brocade Communications Systems Brocade 8/12c Command Reference Manual page 92

22
authUtil
To set the Device policy to passive mode:
To set the device authentication policy to "on" mode:
To start authentication on E/F_Ports 2, 3, and 4:
To disable md5 hash type for FIPS configuration:
SEE ALSO
portShow,
58
switch:admin> authutil --policy -dev passive
Warning: Activating the authentication policy requires
DH-CHAP secrets on both switch and device. Otherwise,
the F-port will be disabled during next F-port
bring-up.
ARE YOU SURE (yes, y, no, n): [no] y
Device authentication is set to PASSIVE
switch:admin> authutil --policy -dev on
Warning: Activating the authentication policy requires
DH-CHAP secrets on both switch and device. Otherwise,
the F-port will be disabled during next F-port
bring-up.
ARE YOU SURE (yes, y, no, n): [no] y
Device authentication is set to ON
2008/03/24-23:13:06, [AUTH-1003], 112,, INFO, Stealth_3,
Device authentication type has been successfully set to ON
switch:admin> authutil --authinit
Warning: Initiating the authentication requires either DH-CHAP
secrets or PKI certificates depending on the protocol selected.
Failed authentication may result in traffic disruption.
Authentication will not be initiated on encrypted ports.
ARE YOU SURE (yes, y, no, n): [no]y
switch:admin> authutil --show
AUTH TYPE HASH TYPE
--------------------------------------
fcap,dhchap sha1,md5
Switch Authentication Policy: PASSIVE
Device Authentication Policy: OFF
switch:admin> authutil --set -h sha1
Hash is set to sha1.
switch:admin> authutil --show
AUTH TYPE HASH TYPE
--------------------------------------
fcap,dhchap sha1
Switch Authentication Policy: PASSIVE
Device Authentication Policy: OFF
secAuthSecret
2,3,4
GROUP TYPE
1
GROUP TYPE
1
Fabric OS Command Reference
53-1001764-01