Fcprlsshow - Brocade Communications Systems Brocade 8/12c Command Reference Manual

22

fcpRlsShow

fcpRlsShow
Displays the Fibre Channel Protocol (FCP) Read Link Status (RLS) information.
SYNOPSIS
fcprlsshow [slot/]port
DESCRIPTION
Use this command to display the FCP RLS information for an F_Port or FL_Port. This information
describes the number of loss-of-signal, loss-of-sync, CRC errors, and other failure events detected on
the specified port.
For this command to gather and display F_Port error statistics, you must enable the following two
configuration parameters:
•
•
Device probing and RLS probing are disabled by default. Use the configure command to enable these
parameters.
NOTES
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
OPERANDS
This command has the following operands:
slot
port
EXAMPLES
To display the FCP RLS information:
SEE ALSO
portLoginShow,
296
Disable Device Probing = 0 (Enables device probing)
Disable RLS Probing = off (Enables RLS probing)
For bladed systems only, specifies the slot number of the port to display, followed
by a slash (/).
Specifies the port number to display, relative to its slot for bladed systems. Use
switchShow for a listing of valid ports. This operand is required.
switch:admin> fcprlsshow 2/5
link fail loss sync
0xda 0 5
0xdc 0 3
portShow
loss sig prtc err bad word crc err
0 0
0 0
525 0
330 0
Fabric OS Command Reference
53-1001764-01