Brocade Communications Systems Brocade 8/12c Command Reference Manual page 192

22
cryptoCfg
--reg -membernode
158
Files to be imported include member node CP certificates and key vault
certificates. Use the cryptocfg --show -file -all command to view all imported
files. The following operands are supported with the --importcommand:
-scp
Imports a specified certificate from an external host using the secure copy (SCP)
protocol. When -scp is specified, the following operands are required:
local_name
Specifies the name to be assigned to the imported certificate. This is a
user-generated file name.
host_IP | host_name
Specifies the IP address or name of the host from which to import the file. To
specify the host by name, it must first be configured with the dnscCnfig
command.
host_username
Specifies the user name for the host. Depending on your host configuration,
this command may prompt for a password.
host_file_path
Specifies the fully qualified path of the file to be imported. The path must
include the file name.
-usb
Imports a file from a mounted USB storage device. This command is valid only on
nodes with an attached USB device. When -usb is specified, the following
operands are required:
dest_filename
Specifies the name to be assigned to the imported file. This is a
user-generated file name.
source_filename
Specifies the name of the certificate on the USB storage device from which
you are importing.
Registers a member node with the group leader. This command is valid only on
the group leader. The encryption group must have been created prior to
performing member node registration. All member nodes and group leaders must
be registered before encryption group discovery and formation can occur.
The order in which member node registration is performed defines group leader
succession. At any given time, there is only one active group leader in an
encryption group. The group leader succession list Specifies the order in which
group leadership is assumed if the current group leader is not available.
The following operands are required when registering a member node with the
group leader:
member_node_WWN
Specifies the switch world wide name of the member node.
member_node_certfile
Specifies the member node CP certificate. You must have exported this file earlier
to external storage and then imported it to the group leader before you can
register a member node. Use the cryptocfg --show -file -all command to view all
imported certificates.
member_node_IP_add
Specifies the IP address of the member node to be registered with the group
leader.
Fabric OS Command Reference
53-1001764-01