Brocade Communications Systems Brocade 8/12c Command Reference Manual page 992

22
supportShow
fcip
ag
dce_hsl
crypto
NOTES
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
This is a diagnostic command and should only be run for diagnostic support.
Output generated by this command may vary by switch configuration and platform. Output may change
without notice.
OPERANDS
This command has the following operands:
slot
port1[-por2]
lines
EXAMPLES
To display debugging information for a single port on a Brocade 5300:
958
FCIP group commands, disabled by default.
Access Gateway group commands, disabled by default.
DCE group commands, enabled by default.
Encryption group commands, disabled by default.
On bladed systems only, specifies a slot number, followed by a slash (/).
Specifies a port or a range of ports for which to display supportShow information.
this operand is optional; if omitted, the command displays information for all ports.
Specifies the number of lines for the portLogDump output. This parameter is
valid only with the slot/port parameters.
switch:admin> supportshow 43
VF
======================
Date:
Sun Dec 6 05:10:13 PST 2009
Time Zone:
America/Los_Angeles
Version:
Kernel: 2.6.14.2
Fabric OS: v6.4.0_main_bld09
Made on: Tue Dec 1 20:04:36 2009
Flash: Wed Dec 2 11:54:49 2009
BootProm: 1.0.15
supportshow groups enabled:
os enabled
exception enabled
port enabled
fabric enabled
services enabled
security enabled
network enabled
portlog enabled
system enabled
extend disabled
Fabric OS Command Reference
53-1001764-01