Supportshow - Brocade Communications Systems Brocade 8/12c Command Reference Manual

supportShow

Displays switch information for debugging purposes.
SYNOPSIS
supportshow
supportshow [slot /]port1[-port2] [lines]
DESCRIPTION
Use this command to display support information from groups of preselected Fabric OS and Linux
commands and other support and debugging information. You can specify a port or a range of ports for
which to display this information. These commands are organized by groups, but note that the order of
the groups listed below is not the same as executed by the command.
The FCIP commands are supported only on the Brocade 7800/FX8-24 and FR4-18i platforms. On
unsupported platforms, the command displays a "not applicable to this platform" message next to the
FCIP command group.
SupportShow executes commands in the following command groups. Use supportShowCfgenable or
supportShowCfgDisable to modify the settings for each group.
os
exception
port
fabric
services
security
network
portlog
system
extend
filter
perfmon
ficon
iswitch
asic_db
Fabric OS Command Reference
53-1001764-01
OS group commands, enabled by default.
Exception group commands, enabled by default.
Port group commands, enabled by default.
Fabric group commands, enabled by default.
Service group commands, enabled by default.
Security group commands, enabled by default.
Network group commands, enabled by default.
Portlog group commands, enabled by default.
System group commands, enabled by default.
Extend group commands, disabled by default.
Filter group commands, disabled by default.
Performance Monitor group commands, disabled by default.
FICON group commands, disabled by default.
FC Router group commands, disabled by default.
ASIC DB group commands, disabled by default.
22
supportShow
957