Brocade Communications Systems Brocade 8/12c Command Reference Manual page 479

Refer to the RFC 2462 specification for more information.
On modular platforms with intelligent blades, the addresses configured for each slot can be shown with
the -slot option. On standalone platforms, all command options are ignored.
NOTES
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
OPERANDS
This command has the following operands:
-cp cp_number
-chassis
-slot slot
-eth0 | -eth1 | -gate
EXAMPLES
To display the IP addresses on a standalone switch:
To display all IP addresses on a Brocade DCX backbone:
Fabric OS Command Reference
53-1001764-01
On dual-CP systems, specifies the CP card number to be displayed (0 or 1).
On dual-CP systems, displays the IP addresses for the chassis.
Specifies the slot for a blade.
For a specified slot, shows only the selected Ethernet interface or the gateway .
This operand is optional with the -slot option.
switch:admin> ipaddrshow
SWITCH
Ethernet IP Address: 192.168.163.238
Ethernet Subnetmask: 255.255.255.0
Gateway IP Address: 192.168.163.1
DHCP: Off
IPv6 Autoconfiguration Enabled: No
Local IPv6 Addresses:
static 1080::8:800:200c:417a/64
switch:admin> ipaddrshow
Chassis
Ethernet IP Address: 10.33.60.85
Ethernet Subnetmask: 255.255.240.0
CP0
Ethernet IP Address: 10.33.60.86
Ethernet Subnetmask: 255.255.240.0
Host Name: cp0
Gateway IP Address: 10.33.48.1
CP1
Ethernet IP Address: 10.33.60.87
Ethernet Subnetmask: 255.255.240.0
Host Name: cp1
Gateway IP Address: 10.33.48.1
Backplane IP address of CP0 : 10.0.0.5
Backplane IP address of CP1 : 10.0.0.6
IPv6 Autoconfiguration Enabled: Yes
Local IPv6 Addresses:
22
ipAddrShow
445