Brocade Communications Systems Brocade 8/12c Command Reference Manual page 811

fcipcircuit
mgmtif
mgmtroute
xtun
Fabric OS Command Reference
53-1001764-01
-d | --detail
Displays a full view configuration details for all configured tunnels when used with
the all port specifier. This view provides an alternative to specifying a specific
VE_Port or to using the --perf option for a comprehensive view.
-I | --ip-address
Displays the IP addresses configured the specified circuits. You must use this
option with either the --summary or the --circuit option.
Displays FCIP circuit configuration and status. The following operands are
supported with portShow fcipcircuit:
circuit_ID
Specifies a single circuit within the FCIP tunnel. The circuit ID is an integer value
between 1 and 19 on the Brocade FX8-24 and 1 and 7 on the Brocade 7800. This
operand is required.
-t | --tcp
Displays the TCP statistics for the specified circuit.
-p | --perf
Displays additional performance information for the specified FCIP circuit.
-q | --qos
Displays the QoS statistics including performance for each priority. This operand
is optional with the --perf option.
Displays the inband management interfaces configured for a specified GbE Port
or for all GbE Ports. For each GbE Port, the display includes the interface status
(enabled or disabled), the interface IPv4 Address, the netmask, effective MTU,
and annotated port flags.
Displays the management routes configured for a specified GbE Port or for all
GbE Ports. For each GbE Port, the display includes the destination IPv4 Address,
the netmask, the gateway address, and annotated port flags. The metric field is
not valid for the Brocade 7800.
Displays FICON and FCP emulation statistics and current runtime conditions for a
specified set of parameters. The following arguments are supported:
-fcp
Displays the SCSI FastWrite/Tape Pipelining command sub-menu when issued
with a VE_Port number. The syntax for -fcp is as follows:
portshow xtun [slot/]\ve_port -fcp [level] [command] [param] [options]
The following optional operands are supported with -fcp to display FCP emulation
statistics and status information:
-help
Displays the command usage. You must specify a VE_Port number to display
the help functions, for example: portshow xtun 7/12 -fcp -help.
level
Specifies the level for which information is displayed. You can specify one or
more of the following levels. With each additional level, this command
generates progressively more information.
-port
Displays data at the port level.
22
portShow
777