Brocade Communications Systems Brocade 8/12c Command Reference Manual page 56

22
ag
AG configuration changes are saved persistently as configuration keys. Use the portCfgNPort
command to set a port as N_Port.
This command supports multiple configurations for mapping device logins to N_Ports for the purposes of
load balancing and redistribution in the event of a fabric change. If multiple mappings are configured, the
system considers the available mappings in a fixed order of priority to determine which of the available
N_Ports should be assigned to the login request. The first eligible mapping is chosen in the order
specified below.
1.
2.
3.
4.
5.
NOTES
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
AG is supported only on selected Brocade hardware platforms. Refer to the Access Gateway
Administrator's Guide for hardware support and AG configuration procedures.
In non-AG mode, only two actions are available: --modeenable and --modeshow.
OPERANDS
This command has the following operands:
--help
--show
--modeshow
--modeenable
--modedisable
--policyshow
22
Device WWN to N_Port
Device WWN to N_Port Group
Automatic device WWN load balancing.
F_Port to N_Port
F_Port to N_Port Group
Displays the command usage.
Displays the current configuration of the Access Gateway. This includes all
N_Ports and F_Ports that are currently online, failover and failback settings as
well as any online F_Ports that are currently mapped to N_Ports. Failover and
failback policies are displayed as enabled (1) or disabled (0).
Displays the current Access Gateway operating mode of the switch as either
enabled or disabled.
Enables Access Gateway mode on a switch. Long distance mode settings should
be cleared for all ports on the NPIV edge switch to which the AG is connected.
Otherwise, the NPIV switch port displays the long distance port type along with
the F_Port.
Disables Access Gateway mode on a switch. After AG mode is disabled, the
switch reboots automatically and comes online with default zone access set to
"No Access". In order to merge the switch to a fabric, set the default zone to "All
Access" and disable/enable the E_Port.
Displays the supported AG port policies and their status as either enabled or
disabled. AG supports four types of policies:
•
Port Grouping (pg) policy: This policy manages failover of an F_Port to a set
of related N_Ports in a port group.
•
Auto Port Configuration (auto): When this policy is enabled, the AG enabled
switch automatically detects available ports and maps F_Ports to N_Ports.
Auto port configuration is disabled by default.
Fabric OS Command Reference
53-1001764-01