Fcrproxyconfig - Brocade Communications Systems Brocade 8/12c Command Reference Manual

fcrProxyConfig

Displays or configures proxy devices presented by an FC Router.
SYNOPSIS
fcrproxyconfig
[-s importedFID devWWN slot]
[-r importedFID devWWN]
DESCRIPTION
Use this command to display or set the persistent configuration of proxy devices presented by the local
FC Router.
When used without operand, this command displays the persistent proxy device configuration;
otherwise, it sets the specified attributes to its new value.
The proxy device must be inactive prior to setting or clearing persistent attributes. Disabling EX_Ports
(using the portDisable command) attached to the relevant edge fabric, removing the device from the
appropriate LSAN zones, or disabling the physical device are valid methods of ensuring a proxy device is
inactive.
Persistent proxy device configuration attributes apply to the local FC Router. Multiple FC Routers
attached to the same edge fabric coordinate to present the same proxy devices. As a result, persistent
proxy device configurations must be consistent across all FC Routers attached to the same edge fabric
or unpredictable results may occur. If the proxy device configuration is not altered, no action is required.
If the configuration is altered, then care must be taken to ensure consistency across all FC Routers
attached to the same edge fabric.
When used without operands, this command displays the following information:
importedFID
devWWN
Slot
Fabric OS Command Reference
53-1001764-01
The imported fabric ID of the proxy device.
The port world wide name of the device.
The slot used for the device WWN. The device WWN-to-slot association is
persistently stored. The slot format is XXYYH, where XX specifies the translate
domain area_ID (valid values include F0H through FFH) and YY specifies the Port
ID value or the low 8-bits of the proxy device address (valid values include 01H
22
fcrProxyConfig
319