Fcipchiptest - Brocade Communications Systems Brocade 8/12c Command Reference Manual

22

fcipChipTest

fcipChipTest
Tests functionality of components in the FCIP complex.
SYNOPSIS
fcipchiptest
[--slot slot]
[-testtype type]
[-unit number]
DESCRIPTION
Use this command to verify the internal registers and memory of the network processor, FCIP FPGA,
compression processor, and GigPHY.
NOTES
This command is supported only on the Brocade FR4-18i.
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
OPERANDS
This command has the following operands:
--slot slot
-testtype type
-unit number
DIAGNOSTICS
When a failure is detected, the test might report one or more of the following error messages:
CHIP_TEST_ERR
CHIP_TEST_CHIP_INIT_ERR
268
Specifies the slot number on which the diagnostic operates. The default is 0.
Specifies the test type to run. By default, the command runs all tests. Valid tests
include the following:
0
All tests
1
Network processor SRAM test
2
FCIP FPGA internal register test
3
FCIP FPGA interrupt test
4
FCIP FPGA checksum test
5
Compression engine MBIST and LBIST
Specifies the GbE port to test. By default, all GbE ports in the specified slot are
used. Valid unit values include the following:
0
GbE port 0
1
GbE port 1
2
All GbE ports
Fabric OS Command Reference
53-1001764-01