Delete Snmp - D-Link DGS-3120-48PC Reference Manual

®
xStack
Parameters
host - Specify the recipient for which the traps are targeted.
<ipaddr> - The IP address of the recipient for which the traps are targeted.
v6host - Specify the IPv6 host address to which the trap packet will be sent. (EI Mode Only)
<ipv6addr> - The IPv6 address of the recipient for which the traps are targeted.
v1 - The least secure of the possible security models.
v2c - The second least secure of the possible security models.
v3 - The most secure of the possible.
noauth_nopriv - Neither support packet authentication nor encrypting.
auth_nopriv - Support packet authentication.
auth_priv - Support packet authentication and encrypting.
<auth_string 32> - Authentication string. If the v1 or v2 is specified, the auth_string presents the
community string, and it must be one of the entries in community table. If the v3 is specified,
the auth_string presents the user name, and it must be one of the entries in the user table.
Restrictions
Only Administrator-level users can issue this command.
Example
To create SNMP host "10.0.0.1" with community string "public":
DGS-3120-24TC:admin# create snmp host 10.0.0.1 v1 public
Command: create snmp host 10.0.0.1 v1 public
Success.
DGS-3120-24TC:admin#

72-14 delete snmp

Description
This command is used to delete a recipient of an SNMP trap operation.
Format
delete snmp [host <ipaddr> | v6host <ipv6addr>]
Parameters
host - The IP address of the recipient for which the traps are targeted.
<ipaddr> - Enter the IP address used for the configuration here.
v6host - The IPv6 address of the recipient for which the traps are targeted. (EI Mode Only)
<ipv6addr> - Enter the IPv6 address used for the configuration here.
Restrictions
Only Administrator-level users can issue this command.
DGS-3120 Series Managed Switch CLI Reference Guide
658