D-Link DGS-3120-48PC Reference Manual page 812

xStack
Tag field value
0x01
0x02
Others
(0x00, 0x03 ~
0x1F, >0x1F)
If the user has configured the VLAN attribute of the RADIUS server (for example, VID 3) and the
802.1X, or MAC-based Access Control authentication is successful, the port will be added to VLAN
3. However, if the user does not configure the VLAN attribute and authenticates successfully, the
port will be kept in its original VLAN. If the VLAN attribute configured on the RADIUS server does
not exist, the port will not be assigned to the requested VLAN.
To assign ACL by RADIUS Server, the proper parameters should be configured on the RADIUS
Server. The table below shows the parameters for an ACL. The RADIUS ACL assignment is only
used in MAC-based Access Control.
The parameters of the Vendor-Specific Attribute are:
RADIUS Tunnel
Attribute
Vendor-ID Defines the vendor.
Vendor-Type Defines the attribute.
Attribute-Specific Used to assign the ACL
Field profile or rule.
®
DGS-3120 Series Managed Switch CLI Reference Guide
String field format
VLAN name (ASCII)
VLAN ID (ASCII)
1. When the switch receives the
VLAN setting string, it will think it is
the VLAN ID first. In other words, the
switch will check all existed VLAN ID
and check if there is one matched.
2. If the switch can find one
matched, it will move to that VLAN.
3. If the switch can not find the
matched VLAN ID, it will think the
VLAN setting string as a "VLAN
Name".
4. Then it will check that it can find
out a matched VLAN Name.
Description
Note
A tag field of greater than 0x1F is
interpreted as the first octet of the
following field.
Value
171 (DLINK)
12 (for ACL profile)
13 (for ACL rule)
ACL Command
For example:
ACL profile: create access_profile
profile_id 6 profile_name 1 ethernet
vlan 0xFFF;
ACL rule: config access_profile
profile_id 6 add access_id
auto_assign ethernet vlan_id 1 port
all deny;
808
Usage
Required
Required
Required