D-Link DGS-3120-48PC Reference Manual page 235

®
xStack
22-14 debug dhcpv6_relay packet (EI Mode Only)
Description
This command is used to enable or disable the debug information flag of the DHCPv6 relay packet,
including packets receiving and sending.
Format
debug dhcpv6_relay packet [all | receiving | sending] state [enable | disable]
Parameters
all - Set packet receiving and sending debug flags.
receiving - Set packet receiving debug flag.
sending - Set packet sending debug flag.
state - Specify the state of the designated flags.
enable - Enable the designated flags.
disable - Disable the designated flags.
Restrictions
Only Administrator-level users can issue this command.
Example
To enabled the DHCPv6 relay packet sending debug:
DGS-3120-24TC:admin#debug dhcpv6_relay packet sending state enable
Command: debug dhcpv6_relay packet sending state enable
Success.
DGS-3120-24TC:admin#
22-15 debug dhcpv6_relay hop_count state (EI Mode Only)
Description
This command is used to enable or disable debug information flag about the hop count.
Format
debug dhcpv6_relay hop_count state [enable | disable]
Parameters
enable - Specify to enable the hop count state.
disable - Specify to disable the hop count state.
Restrictions
Only Administrator-level users can issue this command.
DGS-3120 Series Managed Switch CLI Reference Guide
231