Create Snmp User; Delete Snmp User - D-Link DGS-1100-06/ME Cli Reference Manual

Command
traps
Each command is listed in detail, as follows:

create snmp user

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create an SNMP user on the Switch:
DGS-1100-06/ME:5#create snmp user dlink SW22 v3 MD5 1234 DES jklj22
Command: create snmp user dlink SW22 v3 MD5 1234 DES jklj22
Success!
DGS-1100-06/ME:5#

delete snmp user

Purpose
Syntax
DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
Parameter
To create a new SNMP user and add the user to an SNMP group.
create snmp user <username 32> <groupname 32> [v1 | v2c | v3
[MD5 <auth_password 32> | SHA <auth_password 32> | none ]
[DES <priv_password 32> | none]]
The create snmp user command creates a new SNMP user and
adds the user to an existing SNMP group.
<username 32> − The new SNMP username, up to 32 alphanumeric
characters.
<groupname 32> − The SNMP groupname the new SNMP user is
associated with, up to 32 alphanumeric characters.
auth - The user may also choose the type of authentication
algorithms used to authenticate the snmp user. The choices are:

MD5 − Specifies that the HMAC-MD5-96 authentication
level to be used. md5 may be utilized by entering one of the
following:

<auth password 32> - A string of between 1 and 32
alphanumeric characters used to authorize the agent to
receive packets for the host.

SHA − Specifies that the HMAC-SHA-96 authentication level
will be used.

<priv_password 32> - A string of between 1 and 32
alphanumeric characters used to authorize the agent to
receive packets for the host.

DES − Specifies that the DES authentication level will be
used.
Only administrator or operate-level users can issue this command.
To remove an SNMP user from an SNMP group and also to delete
the associated SNMP group.
delete snmp user <username 32> [v1 | v2c | v3]
42