D-Link DGS-3120-48PC Reference Manual page 773

®
xStack
Format
show wac auth_state ports {<portlist>}
Parameters
ports - Specify a range of member ports to show the status.
<portlist> - (Optional) Enter a list of ports to display here.
Restrictions
None.
Example
Supposed that port 1 is in host-based mode:
1. MAC 00-00-00-00-00-01 is authenticated without VLAN assigned (may be the specified
target VLAN does not exist or target VLAN has not been specified at all), the ID of RX
VLAN will be displayed (RX VLAN ID is 20 and the assigned VLAN ID is 4004 in this
example).
2. MAC 00-00-00-00-00-02 is authenticated with target VLAN assigned, the ID of target
VLAN will be displayed (RX VLAN ID is 20 and the assigned VLAN ID is 1234 in this
example).
3. MAC 00-00-00-00-00-03 failed to pass authentication, the VID field will be shown as "-"
indicating that packets with SA 00-00-00-00-00-03 will be dropped no matter which VLAN
these packets are from.
4. MAC 00-00-00-00-00-04 attempts to start authentication, the VID field will be shown as "-
"until authentication completed.
Supposed that ports 2 and 3 are in port-based mode:
1. MAC 00-00-00-00-00-10 is the MAC which made port 2 pass authentication; MAC address
is followed by "(P)" to indicate the port-based mode authentication. Supposed that port 3 is
in port-based mode:
2. MAC 00-00-00-00-00-20 attempts to start authentication, MAC address is followed by "(P)"
to indicate the port-based mode authentication.
3. MAC 00-00-00-00-00-21 failed to pass authentication, MAC address is followed by "(P)" to
indicate the port-based mode authentication.
DGS-3120 Series Managed Switch CLI Reference Guide
769