Debug Software Command List - D-Link DGS-3120-48PC Reference Manual

xStack
Chapter 22
debug error_log [dump | clear | upload_toTFTP <ipaddr> <path_filename 64>]
debug buffer [utilization | dump | clear | upload_toTFTP <ipaddr> <path_filename 64>]
debug output [module <module_list> | all] [buffer | console]
debug config error_reboot [enable | disable]
debug config state [enable | disable]
debug show jwac auth_info
debug dhcpv6_client state enable
debug dhcpv6_client state disable
debug dhcpv6_client output [buffer | console]
debug dhcpv6_client packet [all | receiving | sending] state [enable | disable]
debug dhcpv6_relay state enable
debug dhcpv6_relay state disable
debug dhcpv6_relay output [buffer | console]
debug dhcpv6_relay packet [all | receiving | sending] state [enable | disable]
debug dhcpv6_relay hop_count state [enable | disable]
22-1 debug error_log
Description
This command is used to dump, clear or upload the software error log to a TFTP server.
Format
debug error_log [dump | clear | upload_toTFTP <ipaddr> <path_filename 64>]
Parameters
dump - Display the debug message of the debug log.
clear - Clear the debug log.
upload_toTFTP - Upload the debug log to a TFTP server specified by IP address.
<ipaddr> - Specify the IPv4 address of the TFTP server.
<path_filename 64> - The pathname specifies the DOS pathname on the TFTP server. It can
be a relative pathname or an absolute pathname. This value can be up to 64 characters
long.
Restrictions
Only Administrator-level users can issue this command.
Example
To dump the error log:
®
DGS-3120 Series Managed Switch CLI Reference Guide
Debug Software Command
List
(EI Mode Only)
(EI Mode Only)
(EI Mode Only)
(EI Mode Only)
(EI Mode Only)
(EI Mode Only)
(EI Mode Only)
221
(EI Mode Only)
(EI Mode Only)