Config Stp Version; Show Stp Instance - D-Link DGS-3120-48PC Reference Manual

®
xStack

50-15 config stp version

Description
This command is used to enable STP globally.
Format
config stp version [mstp | rstp | stp]
Parameters
version - To decide to run under which version of STP.
mstp - Multiple Spanning Tree Protocol.
rstp - Rapid Spanning Tree Protocol.
stp - Spanning Tree Protocol.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure STP version:
DGS-3120-24TC:admin#
Command: config stp version mstp
Success.
DGS-3120-24TC:admin#
To config STP version with the same value of old configuration:
DGS-3120-24TC:admin#
Command: config stp version mstp
Configure value is the same with current value.
Success.
DGS-3120-24TC:admin#

50-16 show stp instance

Description
This command is used to display each instance parameters settings. Value means the instance ID,
if there is no input of this value, all instance will be shown.
Format
show stp instance {<value 0-15>}
DGS-3120 Series Managed Switch CLI Reference Guide
config stp version mstp
config stp version mstp
511