D-Link DGS-3120-48PC Reference Manual page 433

®
xStack
state - Enable or disable the SNMP trap notification of topology change detected state.
enable - Enable the SNMP trap notification of topology change detected.
disable - Disable the SNMP trap notification of topology change detected. The default
notification state is disabled.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To enable topology change notification on ports 1 to 2:
DGS-3120-24TC:admin#config lldp_med notification topo_change ports 1:1-1:2
state enable
Command: config lldp_med notification topo_change ports 1:1-1:2 state enable
Success.
DGS-3120-24TC:admin#
41-17 config lldp_med ports
Description
This command is used to enable or disable transmitting LLDP-MED TLVs. It effectively disables
LLDP-MED on a per-port basis by disabling transmission of TLV capabilities. In this case, the
remote table's objects in the LLDP-MED MIB corresponding to the respective port will not be
populated.
Format
config lldp_med ports [<portlist> | all] med_transmit_capabilities [all | {capabilities |
network_policy | power_pse | inventory}(1)] state [enable | disable]
Parameters
<portlist> - Specify a range of ports to be configured.
all - Specify to set all ports in the system.
med_transit_capabilities - Select to send the LLDP-MED TLV capabilities specified.
all - Select to send capabilities, network policy, and inventory.
capabilities - Specify that the LLDP agent should transmit "LLDP-MED capabilities TLV." If a
user wants to transmit LLDP-MED PDU, this TLV type should be enabled. Otherwise, this
port cannot transmit LLDP-MED PDU.
network_policy - Specify that the LLDP agent should transmit "LLDP-MED network policy
TLV."
power_pse - Specify that the LLDP agent should transmit 'LLDP-MED extended Power via
MDI TLV' if the local device is a PSE device.
inventory - Specify that the LLDP agent should transmit "LLDP-MED inventory TLV."
state - Enable or disable the transmitting of LLDP-MED TLVs.
enable - Enable the transmitting of LLDP-MED TLVs.
disable - Disable the transmitting of LLDP-MED TLVs.
DGS-3120 Series Managed Switch CLI Reference Guide
429