D-Link DGS-3120-48PC Reference Manual page 407

®
xStack
40-2 delete link_aggregation group_id
Description
This command is used to delete a previously configured link aggregation group.
Format
delete link_aggregation group_id <value 1-32>
Parameters
group_id - Specify the group id. The number of link aggregation groups is project dependency.
The group number identifies each of the groups.
<value 1-32> - Enter the group ID value here. This value must be between 1 and 32.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To delete link aggregation group:
DGS-3120-24TC:admin# delete link_aggregation group_id 3
Command: delete link_aggregation group_id 3
Success.
DGS-3120-24TC:admin#
40-3 config link_aggregation group_id
Description
This command is used to configure a previously created link aggregation group.
Format
config link_aggregation group_id <value 1-32> {master_port <port> | ports <portlist> | state
[enable | disable] | trap [enable | disable]}
Parameters
group_id - Specify the group id. The group number identifies each of the groups.
<value 1-32> - Enter the group ID value here. This value must be between 1 and 32.
master_port - (Optional) Master port ID. Specify which port (by port number) of the link
aggregation group will be the master port. All of the ports in a link aggregation group will share
the port configuration with the master port.
<port> - Enter the master port number here.
ports - (Optional) Specify a range of ports that will belong to the link aggregation group. The port
list is specified by listing the lowest switch number and the beginning port number on that
switch, separated by a colon. Then highest switch number, and the highest port number of the
range (also separated by a colon) are specified. The beginning and end of the port list range
DGS-3120 Series Managed Switch CLI Reference Guide
403