D-Link DGS-3120-48PC Reference Manual page 311

Layer 2 managed stackable gigabit switch
Hide thumbs Also See for DGS-3120-48PC:
Table of Contents

Advertisement

®
xStack
Parameters
vlan_name - Specify the name of the VLAN for which IGMP snooping is to be configured.
<vlan_name 32> - Enter the VLAN name here. The VLAN name can be up to 32 characters
long.
vlanid - Specify the VLAN ID for which IGMP snooping is to be configured.
<vlanid_list> - Enter the VLAN ID here.
all - Specify to use all configured VLANs.
state - (Optional) Enable or disable IGMP snooping for the chosen VLAN.
enable - Enter enable to enable IGMP snooping for the chosen VLAN.
disable - Enter disable to disable IGMP snooping for the chosen VLAN.
fast_leave - Enable or disable the IGMP snooping fast leave function.
enable - Enter enable to enable the IGMP snooping fast leave function. If enabled, the
membership is immediately removed when the system receives the IGMP leave message.
disable - Enter disable to disable the IGMP snooping fast leave function.
proxy reporting - Specify IGMP proxy reporting. If enabled, multiple IGMP reports or leave for a
specific (S, G) will be integrated into one report only before sending to the router port.
state - Enable or disable the proxy reporting.
enable - Enable the proxy reporting.
disable - Disable the proxy reporting.
source_ip - Specify the source IP of proxy reporting integrated report. Default value is zero
IP.
<ipaddr> - Enter the IP address.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure IGMP snooping:
DGS-3120-24TC:admin# config igmp_snooping vlan_name default state enable
Command: config igmp_snooping vlan_name default state enable
Success.
DGS-3120-24TC:admin#
33-2
config igmp_snooping rate_limit
Description
This command is used to configure the rate of IGMP control packet that is allowed per port or per
VLAN.
Format
config igmp_snooping rate_limit [ports <portlist> | vlanid <vlanid_list>] [<value 1-1000> |
no_limit]
Parameters
ports - Specify a range of ports to be configured.
<portlist> - Enter the range of ports to be configured here.
DGS-3120 Series Managed Switch CLI Reference Guide
307

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xstack dgs-3120 series

Table of Contents