D-Link DGS-3120-48PC Reference Manual page 345

®
xStack
long.
vlanid - Specify the ID of the VLAN on which the static group resides.
<vlanid_list> - Enter the VLAN ID list here.
<ipv6addr> - Specify the multicast group IP address.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To delete an MLD snooping static group for VLAN 1, group FF1E::1:
DGS-3120-24TC:admin# delete mld_snooping default FF1E::1
Command: delete mld_snooping default FF1E::1
Success.
DGS-3120-24TC:admin#
33-36 config mld_snooping static_group
Description
This command is used to configure an MLD snooping multicast group static member port. When a
port is configured as a static member port, the MLD protocol will not operate on this port. For
example, suppose that a port is a dynamic member port learned by MLD. If this port is configured
as a static member later, then the MLD protocol will stop operating on this port. The MLD protocol
will resume once this port is removed from static member ports. The static member port will only
affect MLD V1 operation.
Format
config mld_snooping static_group [vlan <vlan_name 32> | vlanid <vlanid_list>] <ipv6addr>
[add | delete] <portlist>
Parameters
vlan - Specify the name of the VLAN on which the static group resides.
<vlan_name 32> - Enter the VLAN name here. The VLAN name can be up to 32 characters
long.
vlanid - Specify the ID of the VLAN on which the static group resides.
<vlanid_list> - Enter the VLAN ID list here.
<ipv6addr> - Specify the multicast group IPv6 address.
add - Specify to add the member ports.
delete - Specify to delete the member ports.
<portlist> - Specify a range of ports to be configured.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
DGS-3120 Series Managed Switch CLI Reference Guide
341