Config Scheduling - D-Link DGS-3120-48PC Reference Manual

®
xStack
DGS-3120-24TC:admin#show per_queue bandwidth_control 1:10
Command: show per_queue bandwidth_control 1:10
Queue Bandwidth Control Table On Port: 1:10
Queue Min Rate(Kbit/sec)
0 640
1 640
2 640
3 640
4 No Limit
5 No Limit
6 No Limit
7 No Limit
DGS-3120-24TC:admin#
62-5

config scheduling

Description
This command is used to configure the traffic scheduling mechanism for each CoS queue.
Format
config scheduling {ports [<portlist> | all]} <class_id 0-7> [strict | weight <value 1-127>]
Parameters
ports - Specify a range of ports to be configured.
<portlist> - Enter the list of port used for this configuration here.
<class_id 0-7> - This specifies the 8 hardware priority queues which the config scheduling
command will apply to. The four hardware priority queues are identified by number from 0 to 7
with the 0 queue being the lowest priority.
strict - The queue will operate in strict mode.
weight - Specify the weights for weighted round robin. A value between 0 and n can be specified.
<value 1-127> - Enter the weights for weighted round robin value here. This value must be
between 1 and 127.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the traffic scheduling CoS queue 1 to weight 25 on port 1:10:
DGS-3120-24TC:admin#
Command: config scheduling ports 1:10 1 weight 25
Success.
DGS-3120-24TC:admin#
DGS-3120 Series Managed Switch CLI Reference Guide
Max Rate(Kbit/sec)
No Limit
No Limit
No Limit
No Limit
No Limit
No Limit
No Limit
No Limit
config scheduling ports 1:10 1 weight 25
583