D-Link DGS-3120-48PC Reference Manual page 88

®
xStack
5-28 config admin local_enable
Description
This command is used to config the local enable password of administrator level privilege. When
the user chooses the "local_enable" method to promote the privilege level, the enable password of
local device is needed. When the password information is not specified in the command, the
system will prompt the user to input the password interactively. For this case, the user can only
input the plain text password. If the password is present in the command, the user can select to
input the password in the plain text form or in the encrypted form. The encryption algorithm is
based on SHA-I.
Format
config admin local_enable {encrypt [plain_text | sha_1] <password>}
Parameters
encrypt - (Optional) Specify the password form.
plain_text - Specify the password in plain text form.
sha_1 - Specify the password in SHA-1 encrypted form.
<password> - (Optional) The password for promoting the privilege level. The length for a
password in plain-text form and SHA-1 encrypted form are different.
plain-text: Passwords can be from a minimum of 0 to a maximum of 15 characters.
SHA-1: The length of Encrypted passwords is fixed to 35 bytes longand the password is case-
sensitive.
Restrictions
Only Administrator-level users can issue this command.
Example
To configure the administrator password:
DGS-3120-24TC:admin# config admin local_enable
Command: config admin local_ebable
Enter the old password:
Enter the case-sensitive new password:******
Enter the new password again for confirmation:******
Success.
DGS-3120-24TC:admin#
DGS-3120 Series Managed Switch CLI Reference Guide
84