D-Link DGS-3120-48PC Reference Manual page 334

®
xStack
<vlan_name 32> - Enter the VLAN name here. The VLAN name can be up to 32 characters
long.
vlanid - Specify the ID of the VLAN for which MLD snooping is to be configured.
<vlanid_list> - Enter the VLAN ID list here.
all - Specify all VLANs for which MLD snooping is to be configured.
state - Enable or disable MLD snooping for the chosen VLAN.
enable - Enter enable here to enable MLD snooping for the chosen VLAN.
disable - Enter disable here to disable MLD snooping for the chosen VLAN.
fast_done - Enable or disable MLD snooping fast_leave function.
enable - Enter enable here to enable MLD snooping fast_leave function. If enable, the
membership is immediately removed when the system receive the MLD leave message.
disable - Enter disable here to disable MLD snooping fast_leave function.
proxy reporting - Specify MLD proxy reporting.
state - Enable or disable the proxy reporting.
enable - Enable the proxy reporting.
disable - Disable the proxy reporting.
source_ip - Specify the source IP of proxy reporting integrated report. Default value is zero
IP.
<ipv6addr> - Enter the Ipv6 address.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure MLD snooping:
DGS-3120-24TC:admin# config mld_snooping default state enable
Command: config mld_snooping default state enable
Success.
DGS-3120-24TC:admin#
33-25 config mld_snooping querier
Description
This command is used to configure the timer in seconds between general query transmissions, the
maximum time in seconds to wait for reports from listeners, and the permitted packet loss that is
guaranteed by MLD snooping.
Format
config mld_snooping querier [vlan_name <vlan_name 32> | vlanid <vlanid_list> | all]
{query_interval <sec 1-65535> | max_response_time <sec 1-25> | robustness_variable
<value 1-7> | last_listener_query_interval <sec 1-25> | state [enable | disable] | version
<value 1-2>}(1)
Parameters
vlan_name - Specify the name of the VLAN for which MLD snooping querier is to be configured.
<vlan_name 32> - Enter the VLAN name here. The VLAN name can be up to 32 characters
long.
vlanid - Specify the ID of the VLAN for which MLD snooping querier is to be configured.
DGS-3120 Series Managed Switch CLI Reference Guide
330