D-Link DGS-3120-48PC Reference Manual page 318

®
xStack
DGS-3120-24TC:admin# create igmp_snooping static_group vlan default 239.1.1.1
Command: create igmp_snooping static_group vlan default 239.1.1.1
Success.
DGS-3120-24TC:admin#
33-10 delete igmp_snooping static_group
Description
This command is used to delete an IGMP snooping multicast static group. The deletion of an
IGMP snooping static group will not affect the IGMP snooping dynamic member ports for a group.
Format
delete igmp_snooping static_group [vlan<vlan_name 32> | vlanid <vlanid_list>] <ipaddr>
Parameters
vlan - Specify the name of the VLAN on which the router port resides.
<vlan_name 32> - Enter the VLAN name here. The VLAN name can be up to 32 characters
long.
vlanid - Specify the ID of the VLAN on which the router port resides.
<vlanid_list> - Enter the VLAN ID list here.
<ipaddr> - Specify the multicast group IP address.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To delete an IGMP snooping static group for VLAN 1, group 239.1.1.1:
DGS-3120-24TC:admin# delete igmp_snooping static_group vlan default 239.1.1.1
Command: delete igmp_snooping static_group vlan default 239.1.1.1
Success.
DGS-3120-24TC:admin#
33-11 config igmp_snooping static_group
Description
This command is used to configure IGMP snooping static group. When a port is configured as a
static member port, the IGMP protocol will not operate on this port. For example, suppose that a
port is a dynamic member port learned by IGMP. If this port is configured as a static member later,
then the IGMP protocol will stop operating on this port. The IGMP protocol will resume once this
port is removed from static member ports.
The static member port will only affect V2 IGMP operation.
DGS-3120 Series Managed Switch CLI Reference Guide
314