D-Link DGS-3120-48PC Reference Manual page 463

®
xStack
Restrictions
None.
Example
To display the MAC-based Access Control authentication status on port 1:1-1:4
DGS-3120-24TC:admin#show mac_based_access_control auth_state ports 1:1-1:4
Command: show mac_based_access_control auth_state ports 1:1-1:4
(P): Port-based
Port MAC Address
---- -------------------- -------------- ---- -------- ------------
Total Authenticating Hosts
Total Authenticated Hosts
Total Blocked Hosts
DGS-3120-24TC:admin#
44-17 config mac_based_access_control max_users
Description
This command is used to configure the maximum number of authorized clients.
Format
config mac_based_access_control max_users [<value 1-1000> | no_limit]
Parameters
max_users - Specify to set the maximum number of authorized clients on the whole device. N is
project dependent.
<value 1-1000> - Enter the maximum users here. This value must be between 1 and 1000.
no_limit - Specify to not limit the maximum number of users on the system. By default, there
is no limit on the number of users.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the maximum number of users of the MAC-based Access Control system supports to
128:
DGS-3120 Series Managed Switch CLI Reference Guide
State
: 0
: 0
: 0
459
VID Priority Aging Time/
Block Time