D-Link DGS-3120-48PC Reference Manual page 732

®
xStack
DGS-3120-24TC:admin#show traffic control 1-10
Command: show traffic control 1:1-1:10
Traffic Control Trap
Traffic Control Log
Traffic Control Auto Recover Time : 0 Minutes
Port Thres Broadcast Multicast Unicast
hold Storm
---- ----- --------- --------- -------- -------- -----
1:1 1 Enabled
1:2 1 Enabled
1:3 1 Enabled
1:4 1 Enabled
1:5 1 Enabled
1:6 1 Enabled
1:7 1 Enabled
1:8 1 Enabled
1:9 1 Enabled
1:10 1 Enabled
DGS-3120-24TC:admin#
82-4 config traffic control log state
Description
This command is used to configure the traffic control log state. When the log state is enabled,
traffic control states are logged when a storm occurs and when a storm is cleared. If the log state
is disabled, traffic control events are not logged.
Note: The log state is only applicable for shutdown mode. Since shutdown mode only support
broadcast and multicast storm control, doesn't support unicast storm control. The log only
generate for broadcast and multicast storm control.
Format
config traffic control log state [enable | disable]
Parameters
enable - Both occurred and cleared are logged.
disable - Neither occurred nor cleared is logged.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the traffic log state on the Switch:
DGS-3120 Series Managed Switch CLI Reference Guide
: [None]
: Enabled
Storm Storm
Disabled Disabled shutdown 0
Disabled Disabled shutdown 0
Disabled Disabled shutdown 0
Disabled Disabled shutdown 0
Disabled Disabled shutdown 0
Disabled Disabled shutdown 0
Disabled Disabled shutdown 0
Disabled Disabled shutdown 0
Disabled Disabled shutdown 0
Disabled Disabled shutdown 0
728
Action Count
Down
-------- --------
Time Shutdown
Interval Forever
5
5
5
5
5
5
5
5
5
5