D-Link DGS-3120-48PC Reference Manual page 321

®
xStack
vlanid - Specify the VLAN ID to be configured.
<vlanid_list> - Enter the VLAN ID here.
state - (Optional) Specify to enable or disable the data driven learning of an IGMP snooping
group.
enable - Enter enable to enable the data driven learning option. By default, the state is
enabled.
disable - Enter disable to disable the data driven learning option.
aged_out - (Optional) Enable or disable the aging out of the entry.
enable - Enter enable to enable the aging out of the entry.
disable - Enter disable to disable the aging out of the entry. By default, the state is disabled
state.
expiry_time - (Optional) Specify the data driven group lifetime in seconds. This parameter is
valid only when aged_out is enabled.
<sec 1-65535> - Enter the expiry time here. This value must be between 1 and 65535
seconds.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable the data driven learning of an IGMP snooping group on the default VLAN:
DGS-3120-24TC:admin#
state enable
Command: config igmp_snooping data_driven_learning vlan default state enable
Success.
DGS-3120-24TC:admin#
33-14 config igmp_snooping data_driven_learning
max_learned_entry
Description
This command is used to configure the maximum number of groups that can be learned by data
driven.
When the table is full, the system will stop the learning of the new data-driven groups. Traffic for
the new groups will be dropped.
Format
config igmp_snooping data_driven_learning max_learned_entry <value 1-1024>
Parameters
max_learned_entry - Specify the maximum number of groups that can be learned by data
driven. The suggested default setting is 56. This default setting may vary depending on
projects.
<value 1-1024> - Enter the maximum learning entry value here. This value must be between
1 and 1024.
DGS-3120 Series Managed Switch CLI Reference Guide
config igmp_snooping data_driven_learning vlan default
317