D-Link DGS-3120-48PC Reference Manual page 733

®
xStack
DGS-3120-24TC:admin# config traffic control log state enable
Command: config traffic control log state enable
Success.
DGS-3120-24TC:admin#
82-5 config traffic control auto_recover_time
Description
This command is used to configure the traffic auto recover time that allowed for a port to recover
from shutdown forever status.
Format
config traffic control auto_recover_time [<min 0> | <min 1-65535>]
Parameters
auto_recover_time - The time allowed for auto recovery from shutdown for a port. The default
value is 0, so no auto recovery is possible; the port remains in shutdown forever mode. This
requires manual entry of the CLI command "config ports [ <portlist> | all ] state enable" to
return the port to a forwarding state. The default value is 0, which means disable auto recover
mode, shutdown forever.
<min 0> - Specify that the auto recovery time will be disabled.
<min 1-65535> - Enter the auto recovery time value here. This value must be between 1 and
65535.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the auto recover time to 5 minutes:
DGS-3120-24TC:admin# config traffic control auto_recover_time 5
Command: config traffic control auto_recover_time 5
Success.
DGS-3120-24TC:admin#
DGS-3120 Series Managed Switch CLI Reference Guide
729