Config Stp Version - D-Link DGS-3100 Series Cli Manual

Restrictions
Example usage:
To configure STP

config stp version

Purpose
Syntax
Description
Parameters
externalCost − Defines a metric that indicates the relative cost of
forwarding packets to the specified port list. Port cost can be set
automatically or as a metric value. The default value is auto.
•
auto – Automatically sets the speed for fo
to the specif
De
20000.
•
<value
200000000 to determine the external cost. The lower the
number, the greater the probability the port will be chosen to
forward packets.
hellotime <value 1-10> − The time interval between transmission of
configuration
the bridged L
value may be between 1 and 10 seconds. The default is 2 seconds.
edge [true | false] – tru
ports cannot
status if a to
port normally should not receive BPDU packets. If a BPDU packet is
received it automatically
the port does not have edge port s
p2p [true | false | au
link. P2P ports ar
in that a P2P port
ports transition to
RSTP. A p2p value
status. auto allows the p
and operate as if the p
maintain thi
op eration) the p2p status changes to operate as if the p2p value
were false. The default setting for this parameter is auto.
[enable | disable] − Allows STP to be enabled or disabled for
state
the ports spe
Only adminis
with path cost 19, hellotime set to 5 s
DGS3100# config stp ports
state enable
Success.
DGS3100#
To globally s
config stp version [mstp | rstp | stp]
The config stp version comman
tree to be implemented
mstp – Sets the Mu
the Switch.
ied port(s) in the list for optimal efficien
fault port cost: 100Mbps port = 200000. Gigabit port =
1-200000000> - Defines a value between 1 and
messages by the designated port, to other devices on
AN, thus stating that the Switch is still functioning. The
e designates the port as an edge port. Edge
create loops, however an edge port can lose edge port
pology change creates a potential for a loop. An edge
loses edge port status. false indicates that
to] – true indicates a point-to-point (P2P) shared
e similar to edge ports however they are restricted
must operate in full-duplex. Like edge ports, P2P
a forwarding state rapidly thus benefiting from
of false indicates that the port cannot have p2p
ort to have p2p status whenever possible
2p status were true. If the port cannot
s status (for example if the port is forced to half-duplex
cified in the port list. The default is enable.
trator-level users can issue this command.
econds and state enable for ports 1-5 of module 1.
1:1-1:5 externalCost 19 hellotime 5
et the version of STP on the Switch.
on the Switch.
ltiple Spanning Tree Protocol (MSTP) globally on
61
rwarding packets
tatus.
d sets the version of the spanning
cy.