Ospfv3 Debug Command; Ospfv3 Monitoring Command - D-Link xStack DGS-3610 Series Configuration Manual

DGS-3610 Series Configuration Guide
34.8.1

OSPFv3 Debug Command

In the privileged configuration mode, execute the following commands to start the debug
commands of the OSPFv3 process:
Command
debug ipv6 ospf event
debug ipv6 ospf ifsm
debug ipv6 ospf lsa
debug ipv6 ospf nfsm
debug ipv6 ospf nsm
debug ipv6 ospf packet
debug ipv6 ospf route
Use the above undebug commands to disable the above enabled debug commands.
Caution
34.8.2

OSPFv3 Monitoring Command

In the privileged configuration mode, execute the following commands to start the monitoring
commands of the OSPFv3 process:
Command
show ipv6 ospf
show ipv6 ospf interface [interface-type
interface-number]
The debug commands are provided for technicians.
Running a debug command can affect the performance of the system to
a certain extent.
Therefore, after running the debug commands, be sure to use the
undebug commands to disable the system performance.
Chapter 34 OSPFv3 Configuration
Function
Show the OSPFv3 event information.
Show interface state machine events and
changes.
Show the related OSPFv3 lsa information.
Show neighbor state machine events and
changes.
Show the ospf NSM module related information.
Show the OSPFv3 packet information.
Show the OSPF routing calculation and addition
information.
Function
Show the information of the OSPFv3 process.
Show the interface information of the OSPFv3
process
34-13