Sample Configuration: Virtual Link Trunking - Dell Force10 S4810P Configuration Manual

Figure 54-8. show running-config vlt Command Output on VLT peer switches
FTOS#VLTpeer1#show running-config vlt
!
vlt domain 30
peer-link port-channel 60
back-up destination 10.11.200.18
FTOS#VLTpeer2#show running-config vlt
!
vlt domain 30
peer-link port-channel 60
back-up destination 10.11.200.20
Figure 54-9. show vlt statistics Command Output on VLT peer switches
FTOS_VLTpeer1#show vlt statistics
VLT Statistics
----------------
HeartBeat Messages Sent:
HeartBeat Messages Received:
ICL Hello's Sent:
ICL Hello's Received:
Domain Mismatch Errors:
Version Mismatch Errors:
Config Mismatch Errors:

Sample Configuration: Virtual Link Trunking

To configure virtual link trunking, you must create a VLT domain, configure a backup link and
interconnect trunk, and connect the peer switches in a VLT domain to an attached access device (switch or
server).
Figure 54-10 and
switch.
Figure 54-12 shows how to verify the connection to a VLT domain from an attached switch.
Figure 54-11 show a sample configuration of virtual link trunking on each VLT peer
930
909
927
910
0
0
0
Virtual Link Trunking (VLT) | 1091