Dell Force10 S4810P Configuration Manual page 1077

Use the
delay-restore
restoring the VLT port. Refer to
Configure a VLT port delay period
Step Task
1 Enter VLT-domain configuration mode for a specified
VLT domain.
Range of domain IDs: 1 to 1000.
2 Enter an amount of time, in seconds, to delay the
restoration of the VLT ports after the system is rebooted.
Range: 1-1200
Default: 90 seconds
(Optional) Reconfigure default VLT settings
Step Task
1 Enter VLT-domain configuration mode for a specified
VLT domain.
Range of domain IDs: 1 to 1000.
2 (Optional) After you configure the VLT domain on each
peer switch on both sides of the interconnect trunk, by
default, the FTOS software elects a primary and
secondary VLT peer device.
Use the
primary-priority
primary role of VLT peer switches. To configure the
primary role on a VLT peer, enter a lower
priority value of the remote peer.
Priority values are from 1 to 65535. Default: 32768.
3 (Optional) When you create a VLT domain on a switch,
the FTOS software automatically creates a VLT-system
MAC address used for internal system operations.
Use the
system-mac
the default MAC address for the domain by entering a
new MAC address in the format: aaaa.bbbb.cccc.
You must also reconfigure the same MAC address on
the VLT peer switch.
Use this command to minimize the time required for the
VLT system to synchronize the default MAC address of
the VLT domain on both peer switches when one peer
switch reboots.
command at any time to set an amount of time, in seconds, to delay the system from
VLT Port Delayed Restoration
command to reconfigure the
than the
value
command to explicitly configure
for more information.
Command Syntax
vlt domain domain-id
delay-restore
delay-restore-time
Command Syntax
vlt domain domain-id
primary-priority
value
system-mac mac-address
mac-address
Command Mode
CONFIGURATION
CONFIGURATION
Command Mode
CONFIGURATION
VLT DOMAIN
CONFIGURATION
VLT DOMAIN
CONFIGURATION
Virtual Link Trunking (VLT) | 1077