Displaying Iscsi Optimization Information - Dell S6000–ON Configuration Manual

8. (Optional) Set the aging time for iSCSI session monitoring.
CONFIGURATION mode
[no] iscsi aging time time.
The range is from 5 to 43,200 minutes.
The default is 10 minutes.
9. (Optional) Configures DCBX to send iSCSI TLV advertisements.
LLDP CONFIGURATION mode or INTERFACE LLDP CONFIGURATION mode
[no] advertise dcbx-app-tlv iscsi.
You can send iSCSI TLVs either globally or on a specified interface. The interface configuration takes
priority over global configuration.
The default is Enabled.
10. (Optional) Configures the advertised priority bitmap in iSCSI application TLVs.
LLDP CONFIGURATION mode
[no] iscsi priority-bits.
The default is 4 (0x10 in the bitmap).
11. (Optional) Configures the auto-detection of Compellent arrays on a port.
INTERFACE mode
[no] iscsi profile-compellent.
The default is: Compellent disk arrays are not detected.

Displaying iSCSI Optimization Information

To display information on iSCSI optimization, use the following show commands.
• Display the currently configured iSCSI settings.
show iscsi
• Display information on active iSCSI sessions on the switch.
show iscsi sessions
• Display detailed information on active iSCSI sessions on the switch . To display detailed information
on specified iSCSI session, enter the session's iSCSI ID.
show iscsi sessions detailed [session isid]
• Display all globally configured non-default iSCSI settings in the current Dell Networking OS session.
show run iscsi
Examples of the show iscsi Commands
The following example shows the show iscsi command.
Dell#show iscsi
iSCSI is enabled
iSCSI session monitoring is disabled
iSCSI COS : dot1p is 4 no-remark
Session aging time: 10
468
iSCSI Optimization