At+Cmgc Send An Sms Command - Siemens MC55 Command Set

MC55 AT Command Set
12.2 AT+CMGC
12.2

AT+CMGC Send an SMS command

Syntax
Test Command
AT+CMGC=?
Response(s)
OK
Write Command
If text mode (see
AT+CMGF
,
AT+CMGC=<fo> <ct>
Response(s)
[,
+CMGC: <mr> <scts>
If sending fails
ERROR
+CMS ERROR
Write Command
If PDU mode (see
AT+CMGF
AT+CMGC=<length>
<CR>
Response(s)
[,
+CMGC: <mr> <ackpdu>
OK
If sending fails
ERROR
+CMS ERROR
PIN ASC0 ASC1 MUX1
% % %
Reference(s)
GSM 07.05
Notes
• After invoking the commands
before entering text or PDU. After the prompt a timer will be started to observe the input.
• At baudrates below 19200 it is recommended to use the line termination character only (refer to
) before entering the text or PDU. Use of the line termination character followed by the response format-
<CR>
ting character (refer to
MC55_ATC_V01.05
Confidential / Released
=1)
[, [, [, [,
<pid> <mn> <da>
]
=0)
PDU can be entered
]
MUX2 MUX3
% % %
,
AT+CMGW AT+CMGS
, default can cause problems
ATS4
<LF>
Page 316 of 469
]]]] Text can be entered
<toda>
<CR>
/
<CTRL-Z> <ESC>
or it is necessary to wait for the prompt ">"
AT+CMGC
s
m
obile
/
<CTRL-Z> <ESC>
, default
ATS3
2/10/04