Table of Contents
Advertisement
USER DEFINED KEYS
GENERAL DESCRIPTION
This chapter describes the procedure for defining a numeric key(s) to allow the storage and execution of a list of
commands. The procedure for remote storage and execution of command lists is contained in Section II of this
manual.
ENTERING A COMMAND LIST
The title mode must be activated to enter a command list. When the title mode is activated, the front panel blue
characters, numeric keys, decimal, backspace, and space can be entered onto the top line starting at the upper left
corner of the display. The full width of the display can be used (58 characters total).
Activate title:
Enter command list:
To end a command list:
KEY DEFINITION
After a command list is entered into the title block, it is stored under a defined numeric key(s).
Press:
Select any numeric key(s) (0 - 999) :
Terminate by pressing:
The
command list will not be stored under the numeric
Chapter 12
center frequency = 100 MHz
frequency span = 2 MHz
10 (shift light off)
NOTE
ENTERING A COMMAND LIST
(up to 58 characters)
scan time = 50 msec
key(s).
Manual Operation 109
Advertisement
Table of Contents
