Table of Contents
Advertisement
APPENDIX E
FAST REMOTE OPERATION (KSS AND KST)
To deactivate KSS and leave the analyzer in the same state, execute this command:
OUTPUT 718;"RC0"
NOTE
The p) in "RCO" is a zero and not the letter 0.
FAST PRESET (KST)
The instrument preset command, IP initiates a cycle of operations similar to the five steps outlined before, but with
the addition of an internal bus check. If this check detects any faults, one or both of the INSTR CHECK LEDs
remain on. Fast preset is identical with instrument preset command IP except that it does not perform the internal
bus check. In practice, the instrument bus check routine is not needed every time the instrument is preset;
therefore, the analyzer can be preset with the fast preset command, KST. KST takes approximately 0.2 seconds to
execute; IP takes 0.8 seconds.
4 4 A p p e n d i x
Advertisement
Table of Contents
