Table of Contents
Advertisement
The KS94 command reads the analyzer current LO harmonic number. On execution of KS94, the analyzer sends
a binary code to the controller, which represents the LO harmonic number. The decimal equivalent of this binary
code represents the LO harmonic number such that B represents the 1st harmonic, 1 represents the 2nd harmon-
ic, 2 represents the 3rd harmonic, and so forth.
The analyzer binary code is not followed by a terminator, Therefore, the controller must terminate its own ENTER
command, which it uses to read the binary code. This is the function of the # sign in line 20 of the following
program. This program reads the current LO harmonic number and prints it on the controller CRT
10 OWUT718USING"K,B";"KS";94
20 ENTER718USING"B,#";H
30
PRINTH
40
END
The KS94 command cannot be executed from the front panel.
This is the decimal ASCII equivalent and is transmitted to the analyzer as a single 8-bit byte.
l
KS
84
KS94
Read LO Harmonic Number
P r o g r a m m i n g 2 0 5
Advertisement
Table of Contents
