Table of Contents
Advertisement
The skip-to-next-control-instruction command, SW, instructs the display to skip to the next control word from the
present display memory address. Use SW to omit labels, markers, etc. from the display Display control word
1027 (DW 1027) can be substituted for programming command SW
10
ASSIGN @Sa TO 718
20
OTJTPUT @Sa; "DA 2073 SW,"
30
END
In the example above, display memory address 2073 contains the label control word that places the center
frequency "I I" mark on the CRT However, this marker is omitted from the display because the SW command has
been added to the address.
(See Appendix B.)
Skip to Next Control Instruction
Programming 327
SW
Advertisement
Table of Contents
