Table of Contents
Advertisement
ADVANCED DISPLAY PROGRAMMING
OUTPUT 718;"IP;S2;TS;DA 100;DW
(Note that programming code PS can be substituted for DW 1056.)
A skp written into the trace C page skips the refresh pointer to DA 0 (trace A). This may cause an increase in the
trace intensity because the program
program. An end of display, 1028, is normally used in the Trace C page. This instruction allows a new refresh
cycle to begin.
Skip-to-Next-Control-Instruction
For example, address 2073 of the annotation memory page contains the label control word that places the center
frequency "I 1" mark on the CRT To omit this marker from the display, the label word is replaced by a skc word.
or
(Note that programming code SW can be used for DW 1027.)
Jump (imp).
The example demonstrates jmp by jumping over the data in addresses 100 to 500 in trace A.
Since the jump should be made to a control word, gra is first written into DA 500.
1 8 A p p e n d i x
does
not wait for a refresh trigger before beginning the next execution of the
(skc).
Program control is transferred to the next control instruction.
APPENDIX B
Advertisement
Table of Contents
