Table of Contents
Advertisement
GENERAL INFORMATION
Recorder
outputs
SWEEP
VIDEO
21.4 MHz IF Output
21.4 MHz IF Output
Sweep Plus
Tune Output
Sweep Plus Tune Output
SWEEP + TUNE
MHz
10
Output
10 MHz Output
RECORDER
LOWER
LEFT
A voltage proportional to the horizontal sweep of
the CRT trace that ranges from OV for the left
edge and to + 1OV for the right edge.
Detected video output (before A-D conversion)
proportional to vertical deflection of the CRT
trace. Output increases 100 mV/div from 0 to
A blanking output, 15V occurs during CRT
retrace; otherwise output is low at OV (pen
down).
A 5052, 21.4 MHz output related to the RF input
21.4 MHz
to the analyzer.
IF OUTPUT
In log scales, the IF output is logarithmically
related to the RF input signal; in linear, the out-
put is linearly related.
The output is nominally - 20 dBm for a signal at
the reference level.
The analyzer's resolution bandwidth setting con-
trols the bandwidth. The input attenuator and IF
step gain positions control the amplitude.
OUT
Accuracy:
10 MHzOUT
> - 5 dBm. 50R output impedance
UPPER
RIGHT
output
Output
output
REAR PANEL OUTPUTS
RECORDER Outputs
when keys or HP-IB
commands are enabled
Lower
Left
Right
OV
left
right
o v
+ 1v
lower
+ 15v
Manual Operation 7
Advertisement
Table of Contents
