Config Vlan Access-Profile - Extreme Networks ExtremeWare Command Reference Manual

config vlan access-profile

config vlan <vlan name> access-profile [<access_profile> | none]
Description
Configures a BlackDiamond 6800 running ExtremeWare 4.1 to control the routing of traffic between
VLANs.
Syntax Description
vlan name
access_profile
none
Default
N/A.
Usage Guidelines
This command configures a BlackDiamond 6800 to permit or deny the routing of IP traffic from the
specified list of ingress VLANs to the specified egress VLAN. If the access profile uses permit mode,
only traffic from the VLANs specified in the access profile will be routed to egress VLANs configured to
use that access profile.
The VLAN must already exist. The access profile must be of type VLAN (supported only in
ExtremeWare releases 4.0 and earlier).
Example
Given an access profile created and configured as follows:
create access-profile okprofile vlan
config access-profile okprofile mode permit
config access-profile okprofile add vlan exec
The following command permits traffic from VLAN exec to be routed to VLAN vlan1:
config vlan vlan1 access-profile okprofile
History
This command was available in ExtremeWare 4.1.
Support for this command was discontinued in ExtremeWare 6.0.
Platform Availability
This command is available on the BlackDiamond 6800 MSM32 only.
ExtremeWare Software 7.0.0 Command Reference Guide
Specifies the name of an egress VLAN.
Specifies an access profile that contains a list of ingress VLANs.
Specifies that no access profile should be associated with this VLAN.
config vlan access-profile
609