Download  Print this page

Creating Bobbin Work (embroidery); Selecting The Pattern - Brother Quattro 2 6700D Operation Manual

Embroidery and sewing machine.
Hide thumbs

Advertisement

CREATING BOBBIN WORK (EMBROIDERY)

CREATING BOBBIN WORK (EMBROIDERY)

Selecting the Pattern

Note
• Prepare the machine for bobbin work as
described in "PREPARING FOR BOBBIN
WORK" on page 309.
a
Attach the embroidery foot "W" and the
embroidery unit.
b
Install a bobbin wound with an adequate
amount of thread for pattern.
Note
• For an estimated length of bobbin thread
required for each pattern, refer to the Quick
Reference Guide included with the machine.
Be sure to use a bobbin wound with enough
thread. If the bobbin runs out of thread while
sewing, the embroidery cannot be
completed.
• Depending on the thread thickness, it may
not be possible to wind the bobbin with the
necessary length of thread. In this case, try
winding the bobbin again, or use a lighter
weight thread.
c
Pull up the bobbin thread above the needle
plate.
d
Turn on the machine.
e
Press
→ The carriage will move to the initialization position.
318
.
f
To select a bobbin work embroidery
pattern, press
Note
• Embroidery patterns for bobbin work cannot
be used in the embroidery edit screen
(
).
g
Press
, then advance to page 10 or 11
(page numbers are for small thumbnail size)
of the pattern selection screen for bobbin
work patterns.
h
Select one of the bobbin work embroidery
patterns.
Embroidery patterns for bobbin work appear with
the letter "B" in the lower-left corner of the key.
a
a "B" mark
→ Regardless of the setting that had been selected, the
automatic thread cutting function is turned off.
→ When a bobbin work embroidery pattern is selected
the embroidery sewing speed is automatically set at
350 spm.
Note
• The beginning and end of stitching are
specified for bobbin work patterns. They
cannot be used for normal embroidering.
(Embroidery).

Advertisement

Table of Contents

Troubleshooting

   Related Manuals for Brother Quattro 2 6700D

This manual is also suitable for:

Nv6700d

Comments to this Manuals

Symbols: 0
Latest comments:
  • handyman0031 Jan 03, 2015 10:26:
    please provide a part number for the zigzag embroidery plate,it's included with the 6700 D, however no part number is referenced anywhere in the stupid manual, and there is no item anywhere to replace it? After spending 10 K you think you could put a part number in a book so I can reorder one? my machine jammed and this one has a huge bur on it that cannot be worked out :-(