Download  Print this page

Hemstitching (3) (drawn Work (2)) - Brother Quattro 2 6700D Operation Manual

Embroidery and sewing machine.
Hide thumbs

Advertisement

Table of Contents
b
Select
.
Memo
• For details on each stitch, refer to the
"STITCH SETTING CHART" at the end of
this manual.
c
Attach presser foot "N". With the right side
of the fabric facing up, sew one edge of the
open area.
d
Press
to create a mirror image of the
stitch.
e
Match beginning needle drop points on the
opposite edge of the open area to keep the
stitching symmetrical.

■ Hemstitching (3) (Drawn Work (2))

a
Pull out several threads from both sides of
the 4 mm (approx. 3/16 inch) area which
are not yet open.
*
Pull out four threads, leave five threads, and then
pull out four threads. The width of five threads is
approximately 4 mm (approx. 3/16 inch) or less.
a Approx. 4 mm (approx. 3/16 inch) or less
b Four threads (pull out)
c Five threads (leave)
b
Select
.
Memo
• For details on each stitch, refer to the
"STITCH SETTING CHART" at the end of
this manual.
c
Sew the decorative stitch in the center of
the five threads created above.
Memo
• A wing needle can be used for Hemstitching
(3).
SEWING THE STITCHES
3
131

Advertisement

Table of Contents

Troubleshooting

   Related Manuals for Brother Quattro 2 6700D

This manual is also suitable for:

Nv6700d

Comments to this Manuals

Symbols: 0
Latest comments:
  • handyman0031 Jan 03, 2015 10:26:
    please provide a part number for the zigzag embroidery plate,it's included with the 6700 D, however no part number is referenced anywhere in the stupid manual, and there is no item anywhere to replace it? After spending 10 K you think you could put a part number in a book so I can reorder one? my machine jammed and this one has a huge bur on it that cannot be worked out :-(