Download  Print this page

Pivoting - Brother Quattro 2 6700D Operation Manual

Embroidery and sewing machine.
Hide thumbs


Table of Contents


If the pivot setting is selected, the machine stops
with the needle lowered (in the fabric) and the
presser foot is automatically raised to an
appropriate height when the "Start/Stop" button is
pressed. When the "Start/Stop" button is pressed
again, the presser foot is automatically lowered
and sewing continues. This function is useful for
stopping the machine to rotate the fabric.
• When the pivot setting is selected, the
machine starts when the "Start/Stop" button is
pressed or the foot controller is pressed down
even if the presser foot has been raised. Be
sure to keep your hands and other items away
from the needle, otherwise injuries may occur.
• When the pivot setting is selected, the
height of the presser foot when sewing is
stopped can be changed according to the
type of fabric being sewn. Press
display "Pivoting Height" on 2/8 of the
settings screen. Press
one of the three heights (3.2 mm, 5.0 mm or
7.5 mm). To raise the presser foot further,
increase the setting. (Normally, 3.2 mm is
to select
• The "Needle Position – UP/DOWN" (3/8 of
the settings screen) must be set in the down
used. When "Needle Position – UP/DOWN"
is set in the raised position,
as light gray and cannot be used.
• The pivot function can only be used with
stitches where presser foot J or N is
indicated in the upper-left corner of the
screen. If any other stitch is selected,
appears as light gray and is not available.
• Use the "Presser Foot Lifter" button to make
sure the presser foot is lowered, and then
press the "Start/Stop" button to continue
• If the pivot setting is selected,
beside "Presser Foot Height" in the settings
screen are not available and the setting
cannot be changed.
Select a stitch.
→ The key appears as
for the pivot function to be
to select the pivot setting.


Table of Contents


   Related Manuals for Brother Quattro 2 6700D

This manual is also suitable for:


Comments to this Manuals

Symbols: 0
Latest comments:
  • handyman0031 Jan 03, 2015 10:26:
    please provide a part number for the zigzag embroidery plate,it's included with the 6700 D, however no part number is referenced anywhere in the stupid manual, and there is no item anywhere to replace it? After spending 10 K you think you could put a part number in a book so I can reorder one? my machine jammed and this one has a huge bur on it that cannot be worked out :-(