Download  Print this page

Using The Twin Needle Mode - Brother Quattro 2 6700D Operation Manual

Embroidery and sewing machine.
Hide thumbs

Advertisement

UPPER THREADING
n
Carefully pull the end of the thread that was
passed through the eye of the needle.
*
If a loop was formed in the thread passed through
the eye of the needle, carefully pull on the loop of
thread through to the back of the needle.
Note
• Pulling the loop of thread gently will avoid
needle breakage.
o
Pull out about 10-15 cm (approx. 4-6
inches) of the thread, and then pass it under
the presser foot toward the rear of the
machine.
→ Raise the presser foot lever if the presser foot is
lowered.
a About 10-15 cm (approx. 4-6 inches)
Memo
• If the needle could not be threaded or the
thread was not passed through the needle
bar thread guides, perform the procedure
again starting from step
Then, pass the thread through the eye of the
needle after step
60
c
.
i
.
Note
• Some needles cannot be threaded with the
needle threader. In this case, instead of
using the needle threader after passing the
thread through the needle bar thread guide
(marked "6"), manually pass the thread
through the eye of the needle from the front.

Using the Twin Needle Mode

The twin needle can only be used for patterns that
show
after being selected. Before you select a
stitch pattern, make sure the stitch can be sewn in
the twin needle mode (refer to the "STITCH
SETTING CHART" at the end of this manual).
CAUTION
• Twin needle (part code XE4963-001) is
recommended for this machine. Contact your
authorized dealer for replacement needles
(size 2.0/11 is recommended).
• Be sure to set the twin needle mode when
using the twin needle. Using the twin needle
while the machine is in single needle mode
could cause the needle to break, resulting in
damage.
• Do not sew with bent needles. The needle
could break and cause injury.
• When using the twin needle, it is
recommended to use presser foot "J".
• When the twin needle is used, bunched
stitches may occur depending on the types of
fabric and thread that are used.
Use monogramming foot "N" for decorative
stitches.
• Before changing the needle or threading the
machine, be sure to press
Screen, otherwise injuries may occur if the
"Start/Stop" button or any other button is
pressed and the machine starts sewing.
on the LCD

Advertisement

Table of Contents

Troubleshooting

   Related Manuals for Brother Quattro 2 6700D

This manual is also suitable for:

Nv6700d

Comments to this Manuals

Symbols: 0
Latest comments:
  • handyman0031 Jan 03, 2015 10:26:
    please provide a part number for the zigzag embroidery plate,it's included with the 6700 D, however no part number is referenced anywhere in the stupid manual, and there is no item anywhere to replace it? After spending 10 K you think you could put a part number in a book so I can reorder one? my machine jammed and this one has a huge bur on it that cannot be worked out :-(