Download  Print this page

Brother Quattro 2 6700D Operation Manual Page 273

Embroidery and sewing machine.
Hide thumbs

Advertisement

e
When the following message appears, press
.
→ The pattern will be returned to its original size,
angle, and position as it was before it was edited.
f
Select how to change the pattern size.
*
Press
to enlarge the pattern proportionately.
*
Press
to shrink the pattern proportionately.
*
Press
to stretch the pattern horizontally.
*
Press
to compact the pattern horizontally.
*
Press
to stretch the pattern vertically.
*
Press
to compact the pattern vertically.
*
Press
to return the pattern to its original
appearance.
Memo
• With the density scale bar, the thread den-
sity can be changed.
A setting between 80% and 120% in 5%
increments can be specified.
*
Press
to make the pattern less dense.
*
Press
to make the pattern more dense.
g
Press
.
h
Press
.
Note
• Depending on the pattern, embroidering
may not be possible at the appropriate
thread density. Before sewing on your
project, be sure to sew trial embroidery on a
piece of scrap fabric that is the same as the
fabric used in the project using the same
needle and embroidery thread.
• If the pattern is enlarged and there is space
between stitches, a better effect can be
achieved by increasing the thread density.
• If the pattern is reduced and the stitching is
too thick, a better effect can be achieved by
reducing the thread density.
CAUTION
• Depending on the pattern, the stitching may
become entangled or the needle may break
when the pattern is reduced. If this occurs,
enlarge the pattern slightly.
EDITING PATTERNS
6
271

Advertisement

Table of Contents

Troubleshooting

   Related Manuals for Brother Quattro 2 6700D

This manual is also suitable for:

Nv6700d

Comments to this Manuals

Symbols: 0
Latest comments:
  • handyman0031 Jan 03, 2015 10:26:
    please provide a part number for the zigzag embroidery plate,it's included with the 6700 D, however no part number is referenced anywhere in the stupid manual, and there is no item anywhere to replace it? After spending 10 K you think you could put a part number in a book so I can reorder one? my machine jammed and this one has a huge bur on it that cannot be worked out :-(